Forums

Pages: [1]
Author Topic: !save.. cmds  (Read 876 times)
Soldier
*

Posts: 247
Quote
!savestart [course] [modelpath] (if you want different models)
!savecheckpoint [course] [modelpath] (if you want different models)
!savefinish [course] [modelpath] (if you want different models)


these cmds dont work without a modelpath, is this intended?
   
Maggot
**

Posts: 8
Washed Up Nobody
Does it just default to the frog or does nothing happen?
   
Offline  CrancK
Rocketeer
*

ehh... what?
Posts: 397
dude...
ohw, thats not right, they should work with only course aswell..

ill check.

edit: checked, and they should accept both !save** [course] aswell as !save** [course] [modelpath], code is there, and i didn't change it from last version where it worked... ehm... dunno whats the problem atm, but ill keep searching
« Last Edit: December 27, 2010, 02:20:15 AM by CrancK »


---------------------------
   
Soldier
*

Posts: 247
to help explain a little more..
if you use !savestart 1 (or whatever number) and then do !savefinish 1 it will post to chat what it would normally say. When you go into the menu and then select reload models it also posts to chat what it normally does, but the models dont get reloaded. Ive also opened the menu and done the register map and then used the chat commands with the same results.
   
Offline  CrancK
Rocketeer
*

ehh... what?
Posts: 397
dude...
ahh, ok, will look into it


---------------------------
   
0 Members and 1 Guest are viewing this topic.
Pages: [1]
« previous next »


spirit Powered by SMF 2.0 RC5 | SMF © 2006–2011, Simple Machines LLC